Gas Furnace Parts

Due to the nature of the products we sell directly to homeowners we must have you read and understand our terms of use page. If for any reason you can't understand or agree to these terms we suggest you call a reputable Heating and Air Conditioning Contractor in your area for assistance. Your safety and the manufacturers warranty also requires it. Please click this link.
Terms of Use and Privacy Policy

SEARCH OUR SITE

GAS FURNACE PARTS

Leak Finder Solution(Find your freon or gas leaks fast)

Time Delay Cartridge Fuses(Also a fuse puller)

Blower Motors

Furnace, Air Conditioning Motor Education.

Furnace Motors and Capacitors

Motor Run Capacitor

Hi Speed Motors for Furnaces and Air Handlers ( to overcome poor ductwork or air flow to top floor )

Belt Drive Motor

Motor Brackets

Furnace Blower Repair Parts

Blower Wheels

Fan and Blower Wheel Puller

Motor Brackets

Draft Inducer Assemblies

Inducer Motors (Some brands have photos)

Fan Centers (as found in old furnaces)
Fan center for older furnaces ( Built in transformer and relay on 4"x4" mounting plate )

Flame Sensors:

Trane Flame Sensor SEN 1114(Used in (437) Trane, Cumberland and American Standard furnaces. Come see the full list it fits!)

Trane Flame Sensor SEN00355(Replaces super ceded numbers SEN00246 and SEN00334)

Gas Valves
Robertshaw 700 Series Standing Pilot Furnace Gas Valves

Robertshaw 720 Series Standing Pilot Furnace Gas Valves

HoneywellSmartValve Gas Valves, Ignitor, Fan Timer Boards

Honeywell Gas Spark Ignition Retrofit Kit.

High Temperature Limit switch and Plenum thermostats

Furnace Fan Limit Control ( immersion type as used in older furnaces)

Plenum Thermostats ( as used in newer furnaces)

Goodman Gas Furnace Limit Switches ( Plenum thermostats, aux switches, and spillage switches)

Goodman Gas Furnace Roll Out Switches

Trane High Temp. Limit Switch SWT01280 (for TUE furnaces)

Trane SWT01652 Limit Switch (for TUY 90% furnaces)

Trane High Temperature Plenum Thermostat SWT01729(see list of 77 Trane, Cumberland and American Standard furnaces this fits)

Hot Surface Igniters

Ignition Controls

Amana 1128701A Ign Board(Amana Part number 1128701A also used in EGHE*DA3, EGHW*DA3,EPCG*D/E AND ERGW Models and others. Come read the Installation Instructions here)

Fenwal Direct Spark Ignition Controls( Directly lights burners with no pilot involved)

Fenwal Direct Spark Ign Control
(Robertshaw/Fenwal 35-704600-005 120 Volt Direct Spark Ignition Control.
Series 35-70. Uni-Line 814-009. Mfg # 05-142301-005)

Trane CNT03776 Ignition Control Board(White Rodgers 50E47-860
Replaces CNT01316, CNT01176 and CNT01354)

Trane Direct Spark IgnitionBoard CNT03484(As used in Trane/American Standard YCX, DCX, YCC package units) With photo and instructions

Honeywell Universal Intermittent Spark Ignition (Intermittently lights a pilot assembly)

Honeywell S8610U1003 Intermittent Spark Ignition Control ( Universal replacement for Intermittent Spark Systems. Replaces Penn Johnson, Robertshaw, Fenwal and Camstat brands of ignition systems. See photo and description from Honeywell)

Honeywell S8610U3009 Ignition Control( Universal replacement for Intermittent Spark Systems. Replaces Penn Johnson, Robertshaw, Fenwal and Camstat brands of ignition systems. See photo and description from Honeywell)

Honeywell Direct Spark Ignition ( Directly lights burners with no pilot involved)

Honeywell S87C1030 Direct Spark Ignition Control (Photo and description)

Honeywell S87B1065 Direct Spark Ignition Control (Photo and description)

Honeywell S87D1004 Direct Spark Ignition Control (Photo and description)

Honeywell S87D1012 Direct Spark Ignition Control (Photo and description)

Honeywell S89F1098 Direct Spark Ignition Control (Photo and description)

Robertshaw Ignition Controls

Hot Surface Ignition (HSI)

Robertshaw Universal 780-910 HSI Ignition Control (Photo and description)
Replaces most brands of Hot Surface Ignition modules.

Robertshaw 780-783 Rheem/Ruud Hot Surface Ignition Control (Replaces Rheem/Ruud 62-22578-01. See photo and description)

Robertshaw 780-785 Rheem/Ruud Hot Surface Ignition Ignition Control (Exact Replacement for Rheem/Ruud 62-22578-02. See photo and description)

Robertshaw 780-790 Rheem Water Heater HSI Control (Factory Model HS780-17NL-304A. Part # 100-00812-27. Replacement for Rheem Pt # 41-AP10758)
Robertshaw Evcon Ignition Control(Used in Coleman Evcon, York Furnaces (Also found in some Lennox furnaces and some Rheem water heaters)

Trane Direct Spark IgnitionBoard CNT03484(As used in Trane/American Standard YCX, DCX, YCC package units) With photo and instructions

Intermittent Spark Ignition (Intermittently lights a pilot assembly)

Johnson G776RGD-14 Lennox Ign Control(Replacement for Lennox G20, G20R, G23 and G26 series unit that has a Johnson Controls G776RGD-1, G776RGD-2, G776RGD-10 or G776RGD-11 ignition control installed, or has been replaced with a Lennox 65K93 ignition replacement kit)

Robertshaw 780-001 Ignition Control (For Intermittent Spark Ignition Systems 780-715 Non Lock Out) With photo and cross reference. Used in Carrier-Bryant-BDP-Payne furnaces.
Replaces Carrier # LH33CM600, LH33CZ003. Also P361-3904, 301480-101 and 301121-701.

Robertshaw 780-002 Ignition Control (For Intermittent Spark Ignition Systems with Lock Out. SP735A and others)

Robertshaw 780-003 Ignition Control (For Intermittent Spark Ignition Systems. Lock Out with Pre-Purge) With photo and cross reference. This is a universal kit to replace 735, 735A and 745 units.

Robertshaw 780-715 Ignition Control (For Intermittent Spark Ignition Systems. Replaces SP715 and SP715A flame rectification module with certain gas valves, see listing on the page for gas valves that use this control)

Robertshaw 780-735 Ignition Control (For Intermittent Spark Ignition Systems. Lock out - Flame rectification module with certain gas valves, see listing on the page for gas valves that use this control)

Robertshaw 780-845 Ignition Control(For Intermittent Spark Systems)

White Rodgers Ignition Controls

White Rodgers Direct Spark Ignition Controls( Directly lights burners with no pilot involved)

White Rodgers 50D50-843 Universal Direct Spark Ignition Control(Universal replacement with photo, manufacturer's PDF Installation file and description) With link to the manufacturer.

White Rodgers 50D50-842 Universal Direct Spark Ignition Control (Universal replacement with photo, manufacturer's PDF Installation file and description) With link to the manufacturer.

O.E.M Ignition Controls (Original Equipment Manufacturer)

Amana 1128701A Ignition Board (Amana 1128701A Ignition Board Amana Part number 1128701A also used in EGHE*DA3, EGHW*DA3,EPCG*D/E AND ERGW Models and others. Come read the Installation Instructions here)

Carrier/Bryant/Payne Spark Igniter Control LH33WZ510 (Spark Igniter used in many Carrier/Bryant Payne furnaces)

Carrier/Bryant/Payne Spark Igniter Control LH33WZ512A(Spark Igniter used in many Carrier/Bryant Payne furnaces)

Carrier LH33WP003 Printed Circuit Board (Ignition Control for about 3,000 Carrier/Bryant/Payne Package Units)

Concord Furnace Ignition Control Module 42451-002 Concord Furnace Ignition Control Module 42451-002 As used in Model RGU Series.

Lennox Control Board Kit 65K07 (for G24M3 furnace)

Lennox Ignition Control Module 53L90 (for Models G20-Q5/6X)

Trane Direct Spark IgnitionBoard CNT03484(As used in Trane/American Standard YCX, DCX, YCC package units) With photo and instructions

Miscellaneous

Miscellaneous Air Flow Boosters, Repair Manuals, UV Lamps, Duct Sealing and more...

Pilots

Carrier/Bryant 3 Wire Electronic Pilot Burner

Automatic Pilot Re lighter ( For standing pilots that blow out from down drafts from chimneys)

Millivolt Powerpile Generator ( for wall and floor furnaces that operate without a power source)

Pressure Switches

Goodman Gas Furnace Pressure Switches

Carrier/Bryant Pressure Switch Kit 319338-401, replaces 311209-701

Rheem/Ruud Pressure switch 42-24166-89(As used in Rheem Model RGPK10EAMER, Ruud UGPK10EAMER (2) stage heating furnaces and others. Replaces 42-24166-09. Comes with low and high switches.)

Rheem/Ruud Pressure switch 42-24194-82(As used in Rheem Model RGDJ10EAMER and many others.) Replaces 42-22682-03, 42-24194-02, 42-24335-03, 42-24064-01, 422419402

Rheem/Ruud Pressure switch 42-101233-81, 42-24335-02

Trane Pressure Switch SWT01064(This kit is used in (8) Trane furnaces. Come see list)

Printed Circuit Boards, Control Boards, Fan Timers

Circuit Boards

Relays

RBM 90-340 Switching Relay

Thermocouples

Standing Pilot Thermocouples
(As found in most older furnaces, water heaters and other equipment that uses a continually burning gas pilot)

Transformers

Transformers

Home Hours About Us Contact Terms of Use and Privacy Policy Education Links